Jimusho Triangle Automation

• Motor sizeMAC400-D2 400W
• ModelMAC400-D5

Absolute multiturn encoder without battery Real-time industrial Ethernet: Profinet, EthernetIP, MODBUS TCP, EtherCAT, Powerlink and SercosIII 2 RS422 channels for encoder inoutput and SSI encoder etc. 6IO for capture of position, interrupt, counters, enable, timer and PLC functions Expansion module you can choose between: Basic Modules Programmable Modules Field Bus Modules High Speed Multi-Axis Modules Wireless Modules

• Weight141W

Expansion module you can choose between: Basic Modules Programmable Modules Field Bus Modules High Speed Multi-Axis Modules Wireless Modules Most of them available with either cable glands, DSUB connectors and M12 connectors. See EXPANSION MODULES SELECTION CHART. See the ACCESSORIES, GEARS, POWER SUPPLIES and SPECIAL VERSIONS for further possibilities.

• Step Angle1.8˚
• Insulation classB (130˚C)

Step angle: 1.8˚ Step angle accuracy: 5% Insulation class: B (130˚C) NEMA 42 mounting configuration AINiCo magnets Additional windings and customization options available Complementary Products Gearboxes Encoders

• Quantity4 pcs. M12 connectors
• Model NumberMAC00-R4

This module is also called "nanoPLC” because it is a programmable logic controller with IO. It has 8 inputs and 4 outputs all with 24V PNP and opto-coupler. Also advanced mathematical function like +-* are available. Typical applications for this module are stand-alone operation where the MAC motor must be able to operate as a complete positioning system without the need for an external PLC. While the program is running it is also possible to use the RS232RS485, on the fly, to modify parameters such as position, speed etc. If you prefer to have a Wireless solution see our Bluetooth module MAC00-FB4 or WLAN module MAC00-EW4 that has the same programming facilities.

• Cable length2m cable
• Voltage+10V input

Simple module that can be used for pulsedirection or ±10V analogue control with encoder output for external master controller that close the loop. The analog input can also be used in open loop to control position, velocity or torque. Additional it has RS232 and RS485 for access to PC or PLC for programming or setup. The module contains electronics so the 5V serial signals from the basic motor is translated to RS232 or RS485. It is possible to use both RS232 and RS485 but not at the same time. The RS232 is typical used when commissioning software MacTalk is used to setup or monitor the motor. RS485 is used for industrial communication to PLC or PC that transfer operation data to the motor. You can connect up to 32 motors in parallel on the RS485, and up to 7 motors in parallel on the RS232.

• ModelMAC00-FP2

Profibus DP slave module with baudrate up to 12Mbit. All registers of the MAC motor can be read and written. Isolated IO are available for High speed startstop, End limit and Zero search function. Address can be set up via software or with DIP switch. The module is equipped with cable glands for use in harsh environments and BUS IN and BUS OUT for easy implementation of bus systems. GSD file and program example for Siemens S7 are available for download.