Our Products #5035441

The TRAC-MOUNT Roller Cradles are installed in areas where the belt travels at high speeds with a heavy load, but no impact. The TRAC-MOUNT Roller Cradles are closely spaced to reduce belt sag, while being easy to service and replace.

The XHD 20-Ten Series Primary Cleaner is a conveyor belt primary cleaner, which is normally mounted on the face of the conveyor belt head pulley. The cleaner blades face against the direction of belt travel and are designed to peel off the thick layer of loosely adhering material that often accounts for up to 80% of carry-back. The XHD 20-Ten Series Primary Cleaner is normally used in conjunction with at least one secondary cleaner, such as the Inline Premium Secondary Cleaner, and often with a water spraying system.

The Combi-Cradle features impact rollers in the centre and impact bars on the wings. The rollers are mounted in a sliding base, which allows very close roller spacing, but with the ability to replace rollers in minutes.

The Martin QB1 Cleaner HD combines effective removal of carryback with a long-lasting, one-piece blade. Design Features The one-piece blade is manufactured to utilize Constant Angle Radial Pressure (CARP) technology.The new blade design maintains consistent contact with the belt and constant belt cleaning pressure as it wears, so its effective cleaning performances lasts longer.

he Compact Plus is normally used in conjunction with at least one secondary cleaner, such as the ESS Compact Secondary, and often with a water spray system. For slow moving belts, the cleaner should be positioned lower on the head pulley to ensure the blades are clear of the main material flow. The cleaner requires an access point in the conveyor chute to install and replace the urethane blades. This should be in the form of a covered door of sufficient size to allow a technician to reach in and recover the blades. The access door should comply with all current conveyor and safety regulations.

The Durt Tracker Primary Cleaner is normally used along with at least one other secondary cleaner, such as the Durt Tracker Secondary Cleaner. For optimum results, it should be used with a water spray system. The Durt Tracker Primary Cleaner utilises an extruded polymer track and industrial urethane, designed to control costly material carry-back. It protects the secondary cleaner from being overpowered by excess material, thus increasing its effectiveness. The blade material is a 152mm-wide one-piece cast urethane. These segmented blades can be easily removed by sliding on and off the mainframe track. The cleaner is mono-directional, however, the cleaner will not be damaged by belt direction reversal. The cleaner is suitable for use on crowned head pulleys and damaged or grooved belts, while the urethane blades quickly conform to the belt profile.

Unlike conventional steel rollers manufactured using weldedend hubs, the ESS steel rollers are produced using CPS compositebearing housing to ensure optimum performance, reliability anddurability. Benefits include being belt friendly, superior balance, high impact resistance, and a shell which can be hot vulcanised rubber lagged or galvanised for special applications.