Madox Metal Llc Jehor

• MOQ 500 Short Ton
• DIFFERNT50
• STAINLESSGRIP

Hms 1 & 2 available we are ready to sell hms 1&2 of good quality! contact us for a quotation. our quotation are always updated with the global madox metal llc. we are looking for genuine collaborations with concrete end-buyers / factories. please no agents. contact us !!! contact us !!! contact us !!! by madox metal llc

• MOQ 500 Metric Ton
• STAINLESSBIG SIZE

We offer a wide range of control panels, which caters to the electrical needs of clients in various industries. These control panels are procured from reliable suppliers in the market. The variety of control panels offered in this category include : I. Control Panel For Single Phase Submersible Pump It is available in a range of 0.5 HP to 3 HP, 240 V AC and consist of : MEX contractor Starting and running condensors Miniature circuit breaker Bimetallic overload relay (on demand) II. Control Panel For Single Phase Motor Available in a range of 0.5 HP to 3 HP, 240 V AC and consist of : MEX contractor Bimetallic overload relay DP MCB ( on demand). III. Control Panel For Three Phase Submersible Pump & Motor It is available to customers in a varying range of 1 HP to 10 HP, 415 V AC and consist of: MEX Contractor Bimetallic overload relay Rewire able fuse units TP isolator as main switch Meter volt selector switch Single phase preventor cum dry run protection unit

• MOQ 500 Metric Ton
• STAINLESS5.16

We have seen the old buildings under demolition. The reinforcement rods that we see there are a bit different from those we use today. In earlier days, Mild Steel (MS) rods were used to reinforce RCC components of a building. The surface of the MS rod is smooth. Cement would not adhere very well to the surface of the rods. Hence all rods were hooked at the ends to hold the concrete from deflecting. More time was required for fabrication of the bars. These days, the most commonly used reinforcement bars are technically called as CTD (Cold twisted and deformed) bars or High Yield Strength Deformed (HySD) bars. These bars have a bit more of carbon content than MS bars. More the carbon content, brittle the bars are and lesser is the ductility. These rods have ribs on the surface which obliquely wind around the rod. The core of the rod is of uniform area and is available in different diameters like 8, 10, 12, 16, 20 mm etc. Different grades of steel reinforcement are available depending on the yield strength of the bars. Fe-415 (40 grade), Fe - 500 (50 grade) and Fe - 550 (55 grade) are common. Bars of higher strength are normally used in order to decongest (reducing the number of rods used) the concrete in thin columns and large span beams.